The ST Epic from Easton Archery is your best bet for a high-performance Slim-Technology (ST) target or hunting arrow at a reasonable price. ST Epic is available in five sizes so finding just the right arrows for your bow is that much easier than with arrows that only offer four or three selections. You also have the advantage of the small-diameter ST shaft and the premium-quality HP inserts that combine to provide a higher level of accuracy and penetration in a durable field and hunting arrow. In the 600 size the ST Epic is an NZAP best buy for the young bowhunter or any shooters using lower poundage bows, and it makes a very good target shaft.
ST Epic arrows use the same technology as the popular ST Excel shaft but there are a few important differences. ST Epics are manufactured to higher tolerances than the ST Excel and the HP Insert used in the ST Epic is of a higher quality than the standard ST insert used in the ST Excel. These two factors give the ST Epic a higher potential accuracy than the ST Excel.
Unless you are ordering bare shafts, the price posted is for a complete ready-to-shoot arrow and includes fletching to your specifications with Vanes, an H nock, a HP RPS insert, and a field point all of your choice. Sorry, you don't get a free broadhead. The one in the photo is there for illustrative purposes only and is not included with the arrow.
If you prefer to make you own arrows, ST Epic are also available as a bare shaft with H Nock and HP included in the price. If you click on "Do Not Cut" under the length selection, we will send the inserts to you loose. If you select a length, we will epoxy the inserts in place unless instructed to do otherwise.
The ST Epic arrows are available from NZAP in five sizes: 600, 500, 400, 340, and 300.
* These prices include fletching to your specifications with Elite Plastifletch, Bohning X Vanes, Blazer Vanes Or Duravanes, plus a nock, insert and field point.
Feather fletching cost us more than vanes so there is a slight additional charge for this service.
| Size | Shaft Weight | Spine Span | Stock Length | Nock | Insert | RPS Point |
|---|---|---|---|---|---|---|
| Grains | Deflection in Inches | Inches | Grains | Type | O.D. Inches | |
| 600 | 6.4 | 0.600 | 30 3/8 | 9 | HP-3 | 9/32 |
| 500 | 7.3 | 0.500 | 30 7/8 | 9 | HP-3 | 9/32 |
| 400 | 8.6 | 0.400 | 31 7/8 | 9 | HP-4 | 9/32 |
| 340 | 9.5 | 0.340 | 31 7/8 | 9 | HP-4 | 9/32 |
| 300 | 10 | 0.300 | 32 3/8 | 9 | HP-4 | 9/32 |