NAP Broadheads
Multi-Blade Heads From New Archery Products

NAP Thunderhead Broadheads

Thunderhead Broadheads from New Archery Products have the sharpest blades, the best quality and there is a perfect fit between blades, ferrule and point. You can trust Thunderheads on price, quality and performance - every time!

• Super Sharp Diamize Blades High-Carbon Steel Trophy Tip is hardened for the most devastating durability available on the market
• Stainless Steel Blades have the exclusive Diamize Edge for super-sharpness you can see
• The patented scooped out Slim-line ferrule improves flight and penetration
• The original lock ring, o-ring blade retention system invented by NAP - proven a million times over!

NAP Thunderhead Broadheads come in packets of six broadheads each and are assembled and ready to go hunting. Also included in each pack is a set blade-retaining O-rings and a set of UBARS for fitting your Thunderheads onto thin carbon shafts.

NAP U.B.A.R.'s

U.B.A.R. stands for Uniform Broadhead Adapter Ring. This cleaver little device acts as an interface between the broadhead and thin arrow shafts, such as the Easton ST Axis and the Easton ST Excel.

The Thunderhead o-ring is positioned on the inner surface of the UBAR where it provides the support needed to the rear surface of the broadhead. It also keeps the broadhead properly aligned with the shaft so that it will spin true with no wobble. If you are using standard-diameter carbon shafts or any aluminum shafts, the UBAR ring is not necessary, but they don't do any harm either.

UBARs are particularly recommended for bowhunting with Easton ST Axis, ST Axis FMJ, and ST Epic arrows, but will work with all arrow shafts and all broadheads. They come in packets of six.

NAP O-Ring Blade Retainers

These little rings of hard rubber have several uses. They are placed between the UBAR or the arrow-shaft insert (in the case of larger-diameter arrows) and the base of the broadhead. They keep the blades intact in the ferrule when the broadhead is removed and they assist in aligning the broadhead With the shaft.

Replacement Blades for NAP Broadheads

Naturally, the big advantage to using replaceable-blade broadheads is that when the blades get dull or bent, you simply install a new set and keep hunting. No need to sharpen them at all. Another advantage is that you can replace your sharp hunting blades with a set of aeronautically designed practice blades that are guaranteed to fly just like your hunting blades but will be a lot easier on your target and will be easier to remove from foam target (or any other type of target for that matter).

In the case of the Nitron Mini Broadhead and similar high-tech mini heads, it is usually better to replace the blades rather than trying to resharpen them. Any distortion of the blade angle or orientation will have a profound effect on arrow flight especially when the arrow is traveling at the higher speeds of today's new bows. NAP is justifiably proud of the sharpness of the edge they provide on their blades and it is unlikely that any degree of re sharpening will restore this edge.

Each packet of replacement blades will renew three or six broadheads depending on the number of broadheads in the original package.

NAP Thunderhead Replacement Blades

Each packet of eighteen replacement blades will renew six broadheads. Select broadhead size from the drop down menu below.